Online Guitar Tuner
Tune guitar, bass or ukulele with your device microphone, in standard or alternate tunings. Play one string at a time and adjust until the needle settles in the centre.
How to use the online tuner
- Choose your instrument and tuning. Standard guitar (E A D G B E) is selected. The list also has Drop D, half step down, DADGAD and open tunings, 4 and 5-string bass, and ukulele (G C E A, low G and baritone).
- Select Start listening and allow microphone access when your browser asks. Audio is analysed in this page and never uploaded.
- Play one open string and let it ring. The large note shows the pitch heard; the box underneath shows the closest string in your tuning.
- Turn the tuning peg slowly. “Flat” means tighten slightly; “sharp” means loosen slightly. Stop when the needle stays near the centre and it says “in tune”.
- Check every string twice. Tightening one string slightly changes the tension on the others, so a second pass catches small drifts.
Reading the tuner
| Display | Meaning |
|---|---|
| E2, A2, D3… | The note and octave the tuner hears. Low E is E2; high E is E4. |
| 12 cents flat | Below the note. 100 cents make one semitone (one fret). |
| 8 cents sharp | Above the note. Loosen the string a little. |
| In tune | Within 3 cents of the target, closer than most ears can tell apart. |
| 82.4 Hz | The measured frequency in vibrations per second. |
Standard tuning at A4 = 440 Hz uses these target frequencies:
| String | Note | Frequency |
|---|---|---|
| 6 | E2 | 82.41 Hz |
| 5 | A2 | 110.00 Hz |
| 4 | D3 | 146.83 Hz |
| 3 | G3 | 196.00 Hz |
| 2 | B3 | 246.94 Hz |
| 1 | E4 | 329.63 Hz |
Reference pitch changes every target. Most music uses A = 440 Hz. Some orchestras tune to 442 Hz, and 432 Hz is a popular alternative choice; use the one your band or recording uses.
If the reading jumps around
- Mute the other strings with your fretting hand so only one rings.
- Pluck gently near the middle of the string; a hard attack goes sharp for a moment.
- Move the phone or laptop closer to the guitar and away from fans or traffic noise.
- For electric guitar, play through a clean amp sound. Distortion adds overtones that confuse pitch detection.
- The low E string is the hardest to read. If it keeps showing B or E3, play it a little more softly.
In a loud room, a clip-on tuner that senses vibration is easier to read. See our practice gear guide. For alternate tunings, the alternate tunings guide explains each one, and how to tune a guitar covers tuning technique.
Tuner questions
Why does the tuner need microphone access?
It needs to hear your guitar to measure the pitch. Audio is processed locally in this page and is not recorded, stored or uploaded. Select Stop, or close the page, to switch the microphone off.
Does it work on iPhone and Android?
Yes, in current versions of Safari, Chrome, Edge and Firefox. Allow the microphone when asked. If you denied it earlier, enable it again in the browser’s site settings.
Can I tune a bass or ukulele?
Yes. Choose a bass or ukulele tuning from the list. Bass strings are low and quiet through phone microphones, so pluck firmly, let the note ring, and hold the phone near the bass or amp. Standard ukulele tuning is re-entrant: the G string (4th) is higher than the C string next to it.
Why is my guitar in tune but chords sound off?
Tuning only fixes open strings. If fretted notes are out, the guitar’s intonation or setup may need adjusting by a technician.