Home / Learn / Changing strings
Maintenance · 8 minute read

How to change guitar strings

Fresh strings sound brighter, stay in tune better and feel smoother. Here is a calm, step-by-step way to restring a steel-string guitar.

When to change strings

  • They look dull, dark or rusty, or feel rough under your fingers.
  • The guitar will not stay in tune, or notes sound dull and short.
  • A string has broken. Many players replace the whole set at the same time for an even sound.

How often depends on how much you play and how much your hands sweat. Every one to three months is common for regular players.

What you need

  • A new set of strings for your guitar type: electric, steel-string acoustic or nylon-string classical sets are different.
  • Wire cutters or a string cutter.
  • A string winder (optional, but it saves time).
  • A soft cloth, and a tuner such as our online tuner.

Step by step

  1. Loosen and remove one string at a time. Changing strings one by one keeps tension on the neck balanced and shows you how each string was fitted. Turn the peg until the string is slack, then unwind it.
  2. Remove the old string at the bridge. On many acoustics, ease out the bridge pin gently; on electrics, push the string back through the bridge or body.
  3. Wipe the fretboard where the string was, while it is clear.
  4. Fit the new string at the bridge the same way the old one was fitted. On an acoustic, seat the ball end under the bridge plate and press the pin in while pulling the string up gently.
  5. Thread the string through the tuning post, pull it through, then leave about 5–8 cm (2–3 inches) of slack so there will be a few wraps around the post.
  6. Wind the string so the wraps go downward on the post. Wound strings usually need two to three wraps; plain strings three to five.
  7. Tune up to pitch, trim the excess with cutters, and move to the next string.

Stretching and settling

New strings stretch and go flat for a while. After fitting the full set, tune each string, then gently pull it away from the fretboard along its length and retune. Repeat two or three times. Expect to retune several times in the first day.

Safety tips

  • Wear eye protection if you are not used to string changes; a snapping string can whip.
  • Cut string ends rather than leaving long sharp tails, and dispose of old strings carefully.
  • Never tune a string far above its normal pitch. Use the tuner to stop at the right note.
  • If the bridge lifts, the neck moves noticeably, or anything cracks, stop and take the guitar to a technician.

Reviewed October 2026 by Lee Palmer · How we write our guides · Report an error